Auto Que TCP Client
This module will work like a standard Crestron TCP Client with added functionality.
Our Auto-Que TCP client offers the following additional functionality
|Name||Type||Description and Usage|
|QUE_ENABLED||DIGITAL||Hold HIGH Enables auto que (CLIENT_CONNECT has no effect while signal is HIGH)
LOW Disables auto que
|CLIENT_CONNECT||DIGITAL||Hold HIGH to Connect to the client IP and port number.
(Has no effect when QUE_ENABLED is held HIGH)
|SEND_WOL||DIGITAL||PULSE to send a WOL Magic Packet to the MAC address set in the CLIENT_MAC signal|
Port number used to establish connection on client device.
|CLIENT_IP||STRING||IP Address of the client device (000.000.000.000)|
|CLIENT_MAC||STRING||MAC Address of the client device (AA:BB:CC:DD:EE:FF)
REQUIRED: for Wake On Lan functionality
|CLIENT_TX$||STRING||String data to be sent to the client device.
When QUE_ENABLED is held HIGH, any change in this data will automatically connect,
send, and disconnect regardless of CLIENT_CONNECT status.
|CLIENT_CONNECT_F||DIGITAL||Goes HIGH when there is a valid connection|
|CLIENT_STATUS||ANALOG||Standard TCP client status response (2d = Connected)|
|WOL_SENT||DIGITAL||Ack that the WOL packet was generated and sent|
|MAC_ERROR||DIGITAL||Goes HIGH if there is an invalid MAC address|
|CLIENT_RX$||STRING||String data received from the client|
|QueSize||Decimal||Set to a size larger than your longest intended command string|
|QueTimeout||Seconds||How long (in seconds) to stay connected to a device waiting for a response|
|ConnectTimeout||Seconds||How long (in seconds) to keep atempting to connect to the client device
(in que mode timeout will reset connection, in NON-que mode timeout will throw an error message)
|STRING||Email address used at time of registration. Set to "" for demo mode|
|Registration Key||STRING||Registration key issued at time of purchase. Set to 0 for demo mode|